Skip to main content

What went wrong?

My frames overlap

Camera

What you're seeing

Frames run into each other, or two neighbouring frames share a strip of picture. The gaps between frames are uneven or missing.

Check this first

Check this first

Look at the spacing along the whole roll: is it irregular everywhere, only at a few frames, or only at the end of a 120 roll?

Likely causes, most common first

  1. 01

    Film advance or frame-spacing fault

    Common
    How to tell
    Spacing varies through the roll and frames partly overlap in several places, with no pattern you can link to how you used the camera.
    Test it
    With the lens cap on, shoot a scrap roll right through, winding normally. Develop: if the gaps are still uneven, the advance mechanism is at fault.
    The fix
    Get the advance mechanism repaired.

    Source Nikon (scan: butkus.org), Nikon FM2 (FM2N) instruction manual (specifications)

  2. 02

    Rewind button pressed or not reset during winding

    Occasional
    How to tell
    One or a few overlaps on a roll, often after you touched the rewind button or started rewinding mid-roll. Nikon warns that pressing it during advance stops the film moving and overlap may result.
    Test it
    Wind on and watch the rewind knob: it should turn every time you advance. If it does not, the film is not moving.
    The fix
    Only press the rewind button when you are ready to rewind. After loading a new roll, check the rewind knob turns as you wind.

    Sources Nikon (scan: butkus.org), Nikon FE instruction manual (features/specifications); Nikon (scan: butkus.org), Nikon FM2 (FM2N) instruction manual (specifications)

  3. 03

    Deliberate multiple exposure with slack film

    Occasional
    How to tell
    Overlap or a shifted frame right after a planned double exposure. Manuals warn the frame may not register exactly.
    Test it
    Check your notes or the frame numbers: if the overlap is next to a multiple exposure, this is the cause.
    The fix
    Take up the slack with the rewind knob before the second exposure, and make one blank frame afterwards.

    Sources Asahi/Pentax (scan: butkus.org), Pentax K1000 operating manual (specifications); Nikon (scan: butkus.org), Nikon FM2 (FM2N) instruction manual (specifications)

  4. 04

    120 film wound to the wrong start mark or wrong pressure plate setting

    Occasional
    How to tell
    On 120 only: the first or last frame is cut off, or frames are uneven and the film wound stiffly.
    Test it
    Check the backing-paper arrows line up with the start mark when loading, and that the pressure plate is set to 120, not 220.
    The fix
    Set the start mark and pressure plate as the camera manual says.

    Source Asahi/Pentax (scan: butkus.org), Pentax 67 operating manual (specifications)

Avoiding it next time

  • Check the rewind knob turns as you advance.
  • Don't touch the rewind button mid-roll.

Go deeper